OneLaser XRF Laser Settings for Clear Acrylic

3 verified settings · manufacturer data · co2 rf laser · Updated January 2026

Quick Answer — Best Cut Setting38W

Speed (mm/s)

75%

Power

Passes

Air assist: YesSource: OneLaser

Operation	Speed (mm/s)	Power (%)	Passes	Air Assist	Notes
cut	10	75%	1	✓	Clean flame-polished edge per OneLaser acrylic guidelines.
engrave	350	30%	1	—	Acrylic engraving - moderate speed, lower power for frosted finish.

About Clear Acrylic Settings for the OneLaser XRF

The OneLaser XRF cuts Clear Acrylic cleanly at 10 mm/s with 75% power. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For Clear Acrylic, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for Clear Acrylic on the OneLaser XRF?↓

For cutting Clear Acrylic on the OneLaser XRF, start at 10 mm/s speed and 75% power. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for Clear Acrylic on the OneLaser XRF?↓

Yes — air assist is recommended when cutting Clear Acrylic on the OneLaser XRF. It clears smoke from the cut path, reduces charring, and protects your lens from debris.

How many passes to cut through Clear Acrylic on the OneLaser XRF?↓

The manufacturer recommends 1 pass to cut through Clear Acrylic at 10 mm/s and 75% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my OneLaser XRF cutting through Clear Acrylic?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.