OneLaser XRF Cherry Laser Settings

OneLaser XRF Laser Settings for Cherry

2 verified settings · manufacturer data · co2 rf laser · Updated July 2026

Quick Answer — Best Cut Setting38W

16 mm/s

Speed

80%

Power

Passes

Air assist: YesSource: OneLaser

Operation	Mode	Speed	Power (%)	Passes	Air Assist	Notes
cut	—	16 mm/s	80%	1	✓	Cherry wood cutting.
engrave	—	380 mm/s	50%	1	—	Cherry engraving.

About Cherry Settings for the OneLaser XRF

The OneLaser XRF cuts Cherry cleanly at 16 mm/s with 80% power. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For Cherry, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for Cherry on the OneLaser XRF?↓

For cutting Cherry on the OneLaser XRF, start at 16 mm/s speed and 80% power. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for Cherry on the OneLaser XRF?↓

Yes — air assist is recommended when cutting Cherry on the OneLaser XRF. It clears smoke from the cut path, reduces charring, and protects your lens from debris.

How many passes to cut through Cherry on the OneLaser XRF?↓

The manufacturer recommends 1 pass to cut through Cherry at 16 mm/s and 80% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my OneLaser XRF cutting through Cherry?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.