xTool D1 Wooden Phone Stand Laser Settings

xTool D1 Laser Settings for Wooden Phone Stand

9 verified settings · manufacturer data · diode laser · Updated January 2026

Quick Answer — Best Score Setting20W

Speed (mm/s)

30%

Power

Passes

Source: xTool Material Library

Operation	Speed (mm/s)	Power (%)	Passes	Air Assist	Notes
score	40	30%	1	—	—
fill	180	55%	1	—	—
engrave	80	35%	1	—	—

About Wooden Phone Stand Settings for the xTool D1

The xTool D1 cuts Wooden Phone Stand cleanly at 40 mm/s with 30% power. Because the D1 is available in multiple wattage variants (20W, 10W, 5W), settings are grouped by wattage above — select your laser's wattage to see the right numbers. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For Wooden Phone Stand, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for Wooden Phone Stand on the xTool D1?↓

For cutting Wooden Phone Stand on the xTool D1, start at 40 mm/s speed and 30% power. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for Wooden Phone Stand on the xTool D1?↓

Air assist is strongly recommended when cutting Wooden Phone Stand. It clears smoke from the cut path, reduces charring, and helps protect your laser lens.

How many passes to cut through Wooden Phone Stand on the xTool D1?↓

The manufacturer recommends 1 pass to cut through Wooden Phone Stand at 40 mm/s and 30% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my xTool D1 cutting through Wooden Phone Stand?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.