xTool D1 Cork Desk Pad（2pcs） Laser Settings

xTool D1 Laser Settings for Cork Desk Pad（2pcs）

9 verified settings · manufacturer data · diode laser · Updated January 2026

Quick Answer — Best Engrave Setting20W

180

Speed (mm/s)

20%

Power

Passes

Source: xTool Material Library

Operation	Speed (mm/s)	Power (%)	Passes	Air Assist	Notes
engrave	180	20%	1	—	—
fill	180	20%	1	—	—
score	80	30%	1	—	—

About Cork Desk Pad（2pcs） Settings for the xTool D1

The xTool D1 cuts Cork Desk Pad（2pcs） cleanly at 180 mm/s with 20% power. Because the D1 is available in multiple wattage variants (20W, 10W, 5W), settings are grouped by wattage above — select your laser's wattage to see the right numbers. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For Cork Desk Pad（2pcs）, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for Cork Desk Pad（2pcs） on the xTool D1?↓

For cutting Cork Desk Pad（2pcs） on the xTool D1, start at 180 mm/s speed and 20% power. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for Cork Desk Pad（2pcs） on the xTool D1?↓

Air assist is strongly recommended when cutting Cork Desk Pad（2pcs）. It clears smoke from the cut path, reduces charring, and helps protect your laser lens.

How many passes to cut through Cork Desk Pad（2pcs） on the xTool D1?↓

The manufacturer recommends 1 pass to cut through Cork Desk Pad（2pcs） at 180 mm/s and 20% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my xTool D1 cutting through Cork Desk Pad（2pcs）?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.