xTool D1 ABS Plastic（white） Laser Settings

xTool D1 Laser Settings for ABS Plastic（white）

3 verified settings · manufacturer data · diode laser · Updated January 2026

Quick Answer — Best Engrave Setting2W

Speed (mm/s)

80%

Power

Passes

Source: xTool Material Library

Operation	Speed (mm/s)	Power (%)	Passes	Air Assist	Notes
engrave	80	80%	1	—	—
fill	100	60%	1	—	—
score	30	25%	1	—	—

About ABS Plastic（white） Settings for the xTool D1

The xTool D1 cuts ABS Plastic（white） cleanly at 80 mm/s with 80% power. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For ABS Plastic（white）, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for ABS Plastic（white） on the xTool D1?↓

For cutting ABS Plastic（white） on the xTool D1, start at 80 mm/s speed and 80% power. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for ABS Plastic（white） on the xTool D1?↓

Air assist is strongly recommended when cutting ABS Plastic（white）. It clears smoke from the cut path, reduces charring, and helps protect your laser lens.

How many passes to cut through ABS Plastic（white） on the xTool D1?↓

The manufacturer recommends 1 pass to cut through ABS Plastic（white） at 80 mm/s and 80% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my xTool D1 cutting through ABS Plastic（white）?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.