Algolaser Alpha MK2 Colored Canvas Laser Settings

Algolaser Alpha MK2 Laser Settings for Colored Canvas

1 verified settings · manufacturer data · diode laser · Updated January 2026

Quick Answer — Best Cut Setting20W

33.33

Speed (mm/s)

100%

Power

Passes

Source: Algolaser

Operation	Speed (mm/s)	Power (%)	Passes	Air Assist	Notes
cut	33.33	100%	1	—	—

About Colored Canvas Settings for the Algolaser Alpha MK2

The Algolaser Alpha MK2 cuts Colored Canvas cleanly at 33.33 mm/s with 100% power. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For Colored Canvas, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for Colored Canvas on the Algolaser Alpha MK2?↓

For cutting Colored Canvas on the Algolaser Alpha MK2, start at 33.33 mm/s speed and 100% power. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for Colored Canvas on the Algolaser Alpha MK2?↓

Air assist is strongly recommended when cutting Colored Canvas. It clears smoke from the cut path, reduces charring, and helps protect your laser lens.

How many passes to cut through Colored Canvas on the Algolaser Alpha MK2?↓

The manufacturer recommends 1 pass to cut through Colored Canvas at 33.33 mm/s and 100% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my Algolaser Alpha MK2 cutting through Colored Canvas?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.