Sculpfun S9 Plywood Laser Settings

Sculpfun S9 Laser Settings for Plywood

1 verified settings · manufacturer data · diode laser · Updated January 2026

Quick Answer — Best Engrave Setting5W

13.33

Speed (mm/s)

40%

Power

Passes

Source: Sculpfun Official

Operation	Speed (mm/s)	Power (%)	Passes	Air Assist	Notes
engrave	13.33	40%	1	—	User peter.s settings for 3mm plywood engraving.

About Plywood Settings for the Sculpfun S9

The Sculpfun S9 cuts Plywood cleanly at 13.33 mm/s with 40% power. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For Plywood, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for Plywood on the Sculpfun S9?↓

For cutting Plywood on the Sculpfun S9, start at 13.33 mm/s speed and 40% power. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for Plywood on the Sculpfun S9?↓

Air assist is strongly recommended when cutting Plywood. It clears smoke from the cut path, reduces charring, and helps protect your laser lens.

How many passes to cut through Plywood on the Sculpfun S9?↓

The manufacturer recommends 1 pass to cut through Plywood at 13.33 mm/s and 40% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my Sculpfun S9 cutting through Plywood?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.