xTool P2S Black PU Leather Laser Settings

xTool P2S Laser Settings for Black PU Leather

2 verified settings · manufacturer data · co2 glass laser · Updated July 2026

Quick Answer — Best Fill Setting55W

Fill

Mode

400 mm/s

Speed

15%

Power

Passes

Source: xTool Material Library

Operation	Mode	Speed	Power (%)	Passes	Air Assist	Notes
fill	Fill	400 mm/s	15%	1	—	—
engrave	—	500 mm/s	10%	1	—	—

About Black PU Leather Settings for the xTool P2S

The xTool P2S cuts Black PU Leather cleanly at 400 mm/s with 15% power. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For Black PU Leather, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for Black PU Leather on the xTool P2S?↓

For cutting Black PU Leather on the xTool P2S, start at 400 mm/s speed and 15% power. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for Black PU Leather on the xTool P2S?↓

Air assist is strongly recommended when cutting Black PU Leather. It clears smoke from the cut path, reduces charring, and helps protect your laser lens.

How many passes to cut through Black PU Leather on the xTool P2S?↓

The manufacturer recommends 1 pass to cut through Black PU Leather at 400 mm/s and 15% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my xTool P2S cutting through Black PU Leather?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.