xTool F1 Ultra Wooden Phone Stand Laser Settings

xTool F1 Ultra Laser Settings for Wooden Phone Stand

2 verified settings · manufacturer data · diode laser · Updated January 2026

Quick Answer — Best Score Setting20W

250

Speed (mm/s)

80%

Power

Passes

Source: xTool Material Library

Operation	Speed (mm/s)	Power (%)	Passes	Air Assist	Notes
score	250	80%	1	—	—
fill	600	75%	1	—	—

About Wooden Phone Stand Settings for the xTool F1 Ultra

The xTool F1 Ultra cuts Wooden Phone Stand cleanly at 250 mm/s with 80% power. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For Wooden Phone Stand, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for Wooden Phone Stand on the xTool F1 Ultra?↓

For cutting Wooden Phone Stand on the xTool F1 Ultra, start at 250 mm/s speed and 80% power. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for Wooden Phone Stand on the xTool F1 Ultra?↓

Air assist is strongly recommended when cutting Wooden Phone Stand. It clears smoke from the cut path, reduces charring, and helps protect your laser lens.

How many passes to cut through Wooden Phone Stand on the xTool F1 Ultra?↓

The manufacturer recommends 1 pass to cut through Wooden Phone Stand at 250 mm/s and 80% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my xTool F1 Ultra cutting through Wooden Phone Stand?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.