xTool D1 Pro 10W 5mm Acrylic_brown Laser Settings

xTool D1 Pro 10W Laser Settings for 5mm Acrylic_brown

1 verified settings · manufacturer data · diode laser · Updated January 2026

Quick Answer — Best Score Setting10W

Speed (mm/s)

50%

Power

Passes

Air assist: NoSource: xTool LightBurn Library (10W)

Operation	Speed (mm/s)	Power (%)	Passes	Air Assist	Notes
score	40	50%	1	—	LightBurn Library: Cut

About 5mm Acrylic_brown Settings for the xTool D1 Pro 10W

The xTool D1 Pro 10W cuts 5mm Acrylic_brown cleanly at 40 mm/s with 50% power. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For 5mm Acrylic_brown, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for 5mm Acrylic_brown on the xTool D1 Pro 10W?↓

For cutting 5mm Acrylic_brown on the xTool D1 Pro 10W, start at 40 mm/s speed and 50% power. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for 5mm Acrylic_brown on the xTool D1 Pro 10W?↓

Air assist is not required for 5mm Acrylic_brown on the xTool D1 Pro 10W according to manufacturer data, though it can still help reduce smoke and improve cut quality on organic materials.

How many passes to cut through 5mm Acrylic_brown on the xTool D1 Pro 10W?↓

The manufacturer recommends 1 pass to cut through 5mm Acrylic_brown at 40 mm/s and 50% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my xTool D1 Pro 10W cutting through 5mm Acrylic_brown?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.