xTool D1 Pro 10W 6mm Walnut plywood 30*30 Laser Settings

xTool D1 Pro 10W Laser Settings for 6mm Walnut plywood 30*30

2 verified settings · manufacturer data · diode laser · Updated January 2026

Quick Answer — Best Fill Setting10W

100

Speed (mm/s)

20%

Power

Passes

Air assist: NoSource: xTool LightBurn Library (10W)

Operation	Speed (mm/s)	Power (%)	Passes	Air Assist	Notes
fill	100	20%	1	—	LightBurn Library: Cut
engrave	100	20%	1	—	LightBurn Library: Cut

About 6mm Walnut plywood 30*30 Settings for the xTool D1 Pro 10W

The xTool D1 Pro 10W cuts 6mm Walnut plywood 30*30 cleanly at 100 mm/s with 20% power. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For 6mm Walnut plywood 30*30, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for 6mm Walnut plywood 30*30 on the xTool D1 Pro 10W?↓

For cutting 6mm Walnut plywood 30*30 on the xTool D1 Pro 10W, start at 100 mm/s speed and 20% power. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for 6mm Walnut plywood 30*30 on the xTool D1 Pro 10W?↓

Air assist is not required for 6mm Walnut plywood 30*30 on the xTool D1 Pro 10W according to manufacturer data, though it can still help reduce smoke and improve cut quality on organic materials.

How many passes to cut through 6mm Walnut plywood 30*30 on the xTool D1 Pro 10W?↓

The manufacturer recommends 1 pass to cut through 6mm Walnut plywood 30*30 at 100 mm/s and 20% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my xTool D1 Pro 10W cutting through 6mm Walnut plywood 30*30?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.