ComMarker ComMarker B6 60W MOPA Laser Settings for Brass Ring (1mm)
1 verified settings · manufacturer data · fiber mopa laser · Updated July 2026
| Operation | Mode | Speed | Power (%) | Passes | Air Assist | Notes |
|---|---|---|---|---|---|---|
| cut | — | 25 mm/s | 100% | 30 | — | Engraving & cutting brass rings (~1mm thick). |
About Brass Ring (1mm) Settings for the ComMarker ComMarker B6 60W MOPA
The ComMarker ComMarker B6 60W MOPA cuts Brass Ring (1mm) cleanly at 25 mm/s with 100% power over 30 passes. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.
For Brass Ring (1mm), the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.
Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.
Frequently Asked Questions
What speed and power for Brass Ring (1mm) on the ComMarker ComMarker B6 60W MOPA?↓
For cutting Brass Ring (1mm) on the ComMarker ComMarker B6 60W MOPA, start at 25 mm/s speed and 100% power with 30 passes. These are manufacturer-verified starting points — always test on scrap first.
Do I need air assist for Brass Ring (1mm) on the ComMarker ComMarker B6 60W MOPA?↓
Air assist is strongly recommended when cutting Brass Ring (1mm). It clears smoke from the cut path, reduces charring, and helps protect your laser lens.
How many passes to cut through Brass Ring (1mm) on the ComMarker ComMarker B6 60W MOPA?↓
The manufacturer recommends 30 passes to cut through Brass Ring (1mm) at 25 mm/s and 100% power. If the cut isn't clean, try reducing speed slightly before adding more passes.
Why isn't my ComMarker ComMarker B6 60W MOPA cutting through Brass Ring (1mm)?↓
Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.
More Settings for the ComMarker ComMarker B6 60W MOPA
Save Your Own ComMarker ComMarker B6 60W MOPA Settings
Track what works, get AI predictions for new materials, and share with the community. Laser Lab is free to start.
Save Your ComMarker ComMarker B6 60W MOPA Settings
Track what works. Get AI-predicted starting points for any material.
Try Laser Lab Free →Download as PDF