Algolaser DIY KIT MK2 Dry Leaves Laser Settings

Algolaser DIY KIT MK2 Laser Settings for Dry Leaves

2 verified settings · manufacturer data · diode laser · Updated January 2026

Quick Answer — Best Engrave Setting10W

200

Speed (mm/s)

50%

Power

Passes

Source: Algolaser

Operation	Speed (mm/s)	Power (%)	Passes	Air Assist	Notes
engrave	200	50%	1	—	—

About Dry Leaves Settings for the Algolaser DIY KIT MK2

The Algolaser DIY KIT MK2 cuts Dry Leaves cleanly at 200 mm/s with 50% power. Because the Algolaser DIY KIT MK2 is available in multiple wattage variants (10W, 5W), settings are grouped by wattage above — select your laser's wattage to see the right numbers. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For Dry Leaves, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for Dry Leaves on the Algolaser DIY KIT MK2?↓

For cutting Dry Leaves on the Algolaser DIY KIT MK2, start at 200 mm/s speed and 50% power. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for Dry Leaves on the Algolaser DIY KIT MK2?↓

Air assist is strongly recommended when cutting Dry Leaves. It clears smoke from the cut path, reduces charring, and helps protect your laser lens.

How many passes to cut through Dry Leaves on the Algolaser DIY KIT MK2?↓

The manufacturer recommends 1 pass to cut through Dry Leaves at 200 mm/s and 50% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my Algolaser DIY KIT MK2 cutting through Dry Leaves?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.