Algolaser Delta Dry Leaves Laser Settings

Algolaser Delta Laser Settings for Dry Leaves

2 verified settings · manufacturer data · diode laser · Updated January 2026

Quick Answer — Best Engrave Setting40W

500

Speed (mm/s)

70%

Power

Passes

Source: Algolaser

Operation	Speed (mm/s)	Power (%)	Passes	Air Assist	Notes
engrave	500	70%	1	—	—

About Dry Leaves Settings for the Algolaser Delta

The Algolaser Delta cuts Dry Leaves cleanly at 500 mm/s with 70% power. Because the Algolaser Delta is available in multiple wattage variants (40W, 22W), settings are grouped by wattage above — select your laser's wattage to see the right numbers. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For Dry Leaves, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for Dry Leaves on the Algolaser Delta?↓

For cutting Dry Leaves on the Algolaser Delta, start at 500 mm/s speed and 70% power. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for Dry Leaves on the Algolaser Delta?↓

Air assist is strongly recommended when cutting Dry Leaves. It clears smoke from the cut path, reduces charring, and helps protect your laser lens.

How many passes to cut through Dry Leaves on the Algolaser Delta?↓

The manufacturer recommends 1 pass to cut through Dry Leaves at 500 mm/s and 70% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my Algolaser Delta cutting through Dry Leaves?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.