200x200mm lens Silver Laser Settings

200x200mm lens Laser Settings for Silver

2 verified settings · manufacturer data · fiber mopa laser · Updated July 2026

Quick Answer — Best Cut Setting60W

500

Speed (mm/s)

90%

Power

Passes

Source: OMG Laser

Operation	Mode	Speed (mm/s)	Power (%)	Passes	Air Assist	Notes
mark	—	1500	20%	1	—	Pass 2/2 (clean pass) of silver cutting 1mm thickness recipe.
cut	—	500	90%	1	—	Pass 1/2 of silver cutting 1mm thickness. Wobble 0.05mm/0.1mm size.

About Silver Settings for the 200x200mm lens

The 200x200mm lens cuts Silver cleanly at 500 mm/s with 90% power. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For Silver, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for Silver on the 200x200mm lens?↓

For cutting Silver on the 200x200mm lens, start at 500 mm/s speed and 90% power. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for Silver on the 200x200mm lens?↓

Air assist is strongly recommended when cutting Silver. It clears smoke from the cut path, reduces charring, and helps protect your laser lens.

How many passes to cut through Silver on the 200x200mm lens?↓

The manufacturer recommends 1 pass to cut through Silver at 500 mm/s and 90% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my 200x200mm lens cutting through Silver?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.