Raycus 30W BLACK ON SILVER Laser Settings

Raycus 30W Laser Settings for BLACK ON SILVER

1 verified settings · manufacturer data · fiber laser · Updated July 2026

Quick Answer — Best Mark Setting30W

100 mm/s

Speed

60%

Power

Passes

Source: LaserTips.org

Operation	Mode	Speed	Power (%)	Passes	Air Assist	Notes
mark	—	100 mm/s	60%	1	—	Angle: 0°. Lens: 70mmmm

About BLACK ON SILVER Settings for the Raycus 30W

The Raycus 30W cuts BLACK ON SILVER cleanly at 100 mm/s with 60% power. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For BLACK ON SILVER, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for BLACK ON SILVER on the Raycus 30W?↓

For cutting BLACK ON SILVER on the Raycus 30W, start at 100 mm/s speed and 60% power. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for BLACK ON SILVER on the Raycus 30W?↓

Air assist is strongly recommended when cutting BLACK ON SILVER. It clears smoke from the cut path, reduces charring, and helps protect your laser lens.

How many passes to cut through BLACK ON SILVER on the Raycus 30W?↓

The manufacturer recommends 1 pass to cut through BLACK ON SILVER at 100 mm/s and 60% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my Raycus 30W cutting through BLACK ON SILVER?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.