xTool P3 100 Mesh Coated Screen Laser Settings

xTool P3 Laser Settings for 100 Mesh Coated Screen

2 verified settings · manufacturer data · co2 glass laser · Updated January 2026

Quick Answer — Best Fill Setting80W

600

Speed (mm/s)

50%

Power

Passes

Source: xTool Material Library

Operation	Speed (mm/s)	Power (%)	Passes	Air Assist	Notes
fill	600	50%	1	—	—
engrave	600	50%	1	—	—

About 100 Mesh Coated Screen Settings for the xTool P3

The xTool P3 cuts 100 Mesh Coated Screen cleanly at 600 mm/s with 50% power. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For 100 Mesh Coated Screen, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for 100 Mesh Coated Screen on the xTool P3?↓

For cutting 100 Mesh Coated Screen on the xTool P3, start at 600 mm/s speed and 50% power. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for 100 Mesh Coated Screen on the xTool P3?↓

Air assist is strongly recommended when cutting 100 Mesh Coated Screen. It clears smoke from the cut path, reduces charring, and helps protect your laser lens.

How many passes to cut through 100 Mesh Coated Screen on the xTool P3?↓

The manufacturer recommends 1 pass to cut through 100 Mesh Coated Screen at 600 mm/s and 50% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my xTool P3 cutting through 100 Mesh Coated Screen?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.