Thunder Laser Nova Series (55W RF) Cork Laser Settings

Thunder Laser Nova Series (55W RF) Laser Settings for Cork

2 verified settings · manufacturer data · co2 rf laser · Updated January 2026

Quick Answer — Best Cut Setting55W

100

Speed (mm/s)

90%

Power

Passes

Air assist: YesSource: Thunder Laser

Operation	Speed (mm/s)	Power (%)	Passes	Air Assist	Notes
cut	100	90%	1	✓	Air: 5; Lens: 2''; Power range: 10-90%
engrave	2000	30%	1	—	Air: 0.5

About Cork Settings for the Thunder Laser Nova Series (55W RF)

The Thunder Laser Nova Series (55W RF) cuts Cork cleanly at 100 mm/s with 90% power. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For Cork, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for Cork on the Thunder Laser Nova Series (55W RF)?↓

For cutting Cork on the Thunder Laser Nova Series (55W RF), start at 100 mm/s speed and 90% power. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for Cork on the Thunder Laser Nova Series (55W RF)?↓

Yes — air assist is recommended when cutting Cork on the Thunder Laser Nova Series (55W RF). It clears smoke from the cut path, reduces charring, and protects your lens from debris.

How many passes to cut through Cork on the Thunder Laser Nova Series (55W RF)?↓

The manufacturer recommends 1 pass to cut through Cork at 100 mm/s and 90% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my Thunder Laser Nova Series (55W RF) cutting through Cork?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.