Monport Monport 60W MOPA Brass (Color) Laser Settings

Monport Monport 60W MOPA Laser Settings for Brass (Color)

1 verified settings · manufacturer data · fiber laser · Updated July 2026

Quick Answer — Best Mark Setting60W

100 mm/s

Speed

30%

Power

Passes

Source: Monport

Operation	Mode	Speed	Power (%)	Passes	Air Assist	Notes
mark	—	100 mm/s	30%	1	—	MOPA enables color marking on brass. Frequency: 50-200kHz. Pulse width: 100-250ns

About Brass (Color) Settings for the Monport Monport 60W MOPA

The Monport Monport 60W MOPA cuts Brass (Color) cleanly at 100 mm/s with 30% power. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For Brass (Color), the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for Brass (Color) on the Monport Monport 60W MOPA?↓

For cutting Brass (Color) on the Monport Monport 60W MOPA, start at 100 mm/s speed and 30% power. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for Brass (Color) on the Monport Monport 60W MOPA?↓

Air assist is strongly recommended when cutting Brass (Color). It clears smoke from the cut path, reduces charring, and helps protect your laser lens.

How many passes to cut through Brass (Color) on the Monport Monport 60W MOPA?↓

The manufacturer recommends 1 pass to cut through Brass (Color) at 100 mm/s and 30% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my Monport Monport 60W MOPA cutting through Brass (Color)?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.