Community Mixed Lasers LB-Acrylic Laser Settings

Community Mixed Lasers Laser Settings for LB-Acrylic

1 verified settings · manufacturer data · diode laser · Updated January 2026

Quick Answer — Best Cut Setting

Speed (mm/s)

100%

Power

Passes

Air assist: NoSource: Barn Community LightBurn Library

Operation	Speed (mm/s)	Power (%)	Passes	Air Assist	Notes
cut	15	100%	1	—	LightBurn Library: Cut

About LB-Acrylic Settings for the Community Mixed Lasers

The Community Mixed Lasers cuts LB-Acrylic cleanly at 15 mm/s with 100% power. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For LB-Acrylic, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for LB-Acrylic on the Community Mixed Lasers?↓

For cutting LB-Acrylic on the Community Mixed Lasers, start at 15 mm/s speed and 100% power. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for LB-Acrylic on the Community Mixed Lasers?↓

Air assist is not required for LB-Acrylic on the Community Mixed Lasers according to manufacturer data, though it can still help reduce smoke and improve cut quality on organic materials.

How many passes to cut through LB-Acrylic on the Community Mixed Lasers?↓

The manufacturer recommends 1 pass to cut through LB-Acrylic at 15 mm/s and 100% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my Community Mixed Lasers cutting through LB-Acrylic?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.