Skip to main content

xTool M1 Ultra Laser Settings for 1/8"(3mm) Red Acrylic

8 verified settings · manufacturer data · diode laser · Updated July 2026

Quick Answer — Best Cut Setting20W
4 mm/s
Speed
90%
Power
2
Passes
Source: xTool Material Library
OperationModeSpeedPower (%)PassesAir AssistNotes
scoreLine150 mm/s80%1——
fillFill200 mm/s50%1——
engrave—180 mm/s70%1——
cut—4 mm/s90%2——

About 1/8"(3mm) Red Acrylic Settings for the xTool M1 Ultra

The xTool M1 Ultra cuts 1/8"(3mm) Red Acrylic cleanly at 4 mm/s with 90% power over 2 passes. Because the M1 Ultra is available in multiple wattage variants (20W, 10W), settings are grouped by wattage above — select your laser's wattage to see the right numbers. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For 1/8"(3mm) Red Acrylic, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for 1/8"(3mm) Red Acrylic on the xTool M1 Ultra?↓

For cutting 1/8"(3mm) Red Acrylic on the xTool M1 Ultra, start at 4 mm/s speed and 90% power with 2 passes. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for 1/8"(3mm) Red Acrylic on the xTool M1 Ultra?↓

Air assist is strongly recommended when cutting 1/8"(3mm) Red Acrylic. It clears smoke from the cut path, reduces charring, and helps protect your laser lens.

How many passes to cut through 1/8"(3mm) Red Acrylic on the xTool M1 Ultra?↓

The manufacturer recommends 2 passes to cut through 1/8"(3mm) Red Acrylic at 4 mm/s and 90% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my xTool M1 Ultra cutting through 1/8"(3mm) Red Acrylic?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.

Save Your Own xTool M1 Ultra Settings

Track what works, get AI predictions for new materials, and share with the community. Laser Lab is free to start.

Laser Lab

Save Your xTool M1 Ultra Settings

Track what works. Get AI-predicted starting points for any material.

Try Laser Lab Free →Download as PDF

Machine Info

BrandxTool
ModelM1 Ultra
Laser Typediode
Variants20W, 10W
Records8
Browse all xTool M1 Ultra materials →