Epilog Fusion 75W Plastic Laser Settings

Epilog Fusion 75W Laser Settings for Plastic

4 verified settings · manufacturer data · co2 rf laser · Updated February 2026

Quick Answer — Best Cut Setting75W

200

Speed (mm/s)

40%

Power

Passes

Source: Epilog Laser

Operation	Speed (mm/s)	Power (%)	Passes	Air Assist	Notes
cut	200	40%	1	—	Cutting 1/16" (1.5 mm)
engrave	1800	20%	1	—	Engraving

About Plastic Settings for the Epilog Fusion 75W

The Epilog Fusion 75W cuts Plastic cleanly at 200 mm/s with 40% power. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For Plastic, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for Plastic on the Epilog Fusion 75W?↓

For cutting Plastic on the Epilog Fusion 75W, start at 200 mm/s speed and 40% power. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for Plastic on the Epilog Fusion 75W?↓

Air assist is strongly recommended when cutting Plastic. It clears smoke from the cut path, reduces charring, and helps protect your laser lens.

How many passes to cut through Plastic on the Epilog Fusion 75W?↓

The manufacturer recommends 1 pass to cut through Plastic at 200 mm/s and 40% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my Epilog Fusion 75W cutting through Plastic?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.