Epilog Fusion 120W Laser Settings for Rubber/Silicone
2 verified settings · manufacturer data · co2 rf laser · Updated July 2026
| Operation | Mode | Speed | Power (%) | Passes | Air Assist | Notes |
|---|---|---|---|---|---|---|
| engrave | — | 1,600 mm/s | 100% | 1 | — | Engraving |
| cut | — | 600 mm/s | 100% | 1 | — | Cutting |
About Rubber/Silicone Settings for the Epilog Fusion 120W
The Epilog Fusion 120W cuts Rubber/Silicone cleanly at 600 mm/s with 100% power. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.
For Rubber/Silicone, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.
Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.
Frequently Asked Questions
What speed and power for Rubber/Silicone on the Epilog Fusion 120W?↓
For cutting Rubber/Silicone on the Epilog Fusion 120W, start at 600 mm/s speed and 100% power. These are manufacturer-verified starting points — always test on scrap first.
Do I need air assist for Rubber/Silicone on the Epilog Fusion 120W?↓
Air assist is strongly recommended when cutting Rubber/Silicone. It clears smoke from the cut path, reduces charring, and helps protect your laser lens.
How many passes to cut through Rubber/Silicone on the Epilog Fusion 120W?↓
The manufacturer recommends 1 pass to cut through Rubber/Silicone at 600 mm/s and 100% power. If the cut isn't clean, try reducing speed slightly before adding more passes.
Why isn't my Epilog Fusion 120W cutting through Rubber/Silicone?↓
Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.
More Settings for the Epilog Fusion 120W
Rubber/Silicone Settings for Other Machines
- Epilog Zing 60W — rubber/silicone settings(3)
- Epilog Zing 40W — rubber/silicone settings(3)
- Epilog Zing 30W — rubber/silicone settings(3)
- Epilog Zing 50W — rubber/silicone settings(3)
- Laserscript Laserscript LS6090 — rubber/silicone settings(3)
- Epilog Fusion 30W — rubber/silicone settings(2)
- Epilog Fusion 40W — rubber/silicone settings(2)
- Epilog Fusion 60W — rubber/silicone settings(2)
Save Your Own Epilog Fusion 120W Settings
Track what works, get AI predictions for new materials, and share with the community. Laser Lab is free to start.
Save Your Epilog Fusion 120W Settings
Track what works. Get AI-predicted starting points for any material.
Try Laser Lab Free →Download as PDF