xTool F1 Laser Settings for Silver-black Leather

4 verified settings · manufacturer data · diode laser · Updated January 2026

Quick Answer — Best Cut Setting10W

Speed (mm/s)

90%

Power

Passes

Source: xTool Material Library

Operation	Speed (mm/s)	Power (%)	Passes	Air Assist	Notes
score	160	50%	1	—	—
fill	500	70%	1	—	—
cut	10	90%	1	—	—

About Silver-black Leather Settings for the xTool F1

The xTool F1 cuts Silver-black Leather cleanly at 10 mm/s with 90% power. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For Silver-black Leather, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for Silver-black Leather on the xTool F1?↓

For cutting Silver-black Leather on the xTool F1, start at 10 mm/s speed and 90% power. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for Silver-black Leather on the xTool F1?↓

Air assist is strongly recommended when cutting Silver-black Leather. It clears smoke from the cut path, reduces charring, and helps protect your laser lens.

How many passes to cut through Silver-black Leather on the xTool F1?↓

The manufacturer recommends 1 pass to cut through Silver-black Leather at 10 mm/s and 90% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my xTool F1 cutting through Silver-black Leather?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.