xTool F1 3mm Black Walnut Plywood Laser Settings

xTool F1 Laser Settings for 3mm Black Walnut Plywood

4 verified settings · manufacturer data · diode laser · Updated January 2026

Quick Answer — Best Cut Setting10W

Speed (mm/s)

100%

Power

Passes

Source: xTool Material Library

Operation	Speed (mm/s)	Power (%)	Passes	Air Assist	Notes
fill	150	45%	1	—	—
cut	12	100%	9	—	—
score	80	80%	1	—	—

About 3mm Black Walnut Plywood Settings for the xTool F1

The xTool F1 cuts 3mm Black Walnut Plywood cleanly at 12 mm/s with 100% power over 9 passes. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For 3mm Black Walnut Plywood, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for 3mm Black Walnut Plywood on the xTool F1?↓

For cutting 3mm Black Walnut Plywood on the xTool F1, start at 12 mm/s speed and 100% power with 9 passes. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for 3mm Black Walnut Plywood on the xTool F1?↓

Air assist is strongly recommended when cutting 3mm Black Walnut Plywood. It clears smoke from the cut path, reduces charring, and helps protect your laser lens.

How many passes to cut through 3mm Black Walnut Plywood on the xTool F1?↓

The manufacturer recommends 9 passes to cut through 3mm Black Walnut Plywood at 12 mm/s and 100% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my xTool F1 cutting through 3mm Black Walnut Plywood?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.