xTool F1 Lite 1/8"(3mm) Carrot Orange Acrylic Laser Settings

xTool F1 Lite Laser Settings for 1/8"(3mm) Carrot Orange Acrylic

4 verified settings · manufacturer data · diode laser · Updated January 2026

Quick Answer — Best Cut Setting10W

Speed (mm/s)

100%

Power

Passes

Source: xTool Material Library

Operation	Speed (mm/s)	Power (%)	Passes	Air Assist	Notes
fill	150	60%	1	—	—
score	40	80%	1	—	—
cut	2	100%	3	—	—

About 1/8"(3mm) Carrot Orange Acrylic Settings for the xTool F1 Lite

The xTool F1 Lite cuts 1/8"(3mm) Carrot Orange Acrylic cleanly at 2 mm/s with 100% power over 3 passes. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For 1/8"(3mm) Carrot Orange Acrylic, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for 1/8"(3mm) Carrot Orange Acrylic on the xTool F1 Lite?↓

For cutting 1/8"(3mm) Carrot Orange Acrylic on the xTool F1 Lite, start at 2 mm/s speed and 100% power with 3 passes. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for 1/8"(3mm) Carrot Orange Acrylic on the xTool F1 Lite?↓

Air assist is strongly recommended when cutting 1/8"(3mm) Carrot Orange Acrylic. It clears smoke from the cut path, reduces charring, and helps protect your laser lens.

How many passes to cut through 1/8"(3mm) Carrot Orange Acrylic on the xTool F1 Lite?↓

The manufacturer recommends 3 passes to cut through 1/8"(3mm) Carrot Orange Acrylic at 2 mm/s and 100% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my xTool F1 Lite cutting through 1/8"(3mm) Carrot Orange Acrylic?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.