xTool F1 Lite 0.2mm Kraft Paper Laser Settings

xTool F1 Lite Laser Settings for 0.2mm Kraft Paper

3 verified settings · manufacturer data · diode laser · Updated January 2026

Quick Answer — Best Cut Setting10W

Speed (mm/s)

90%

Power

Passes

Source: xTool Material Library

Operation	Speed (mm/s)	Power (%)	Passes	Air Assist	Notes
cut	20	90%	1	—	—
fill	300	60%	1	—	—
score	150	60%	1	—	—

About 0.2mm Kraft Paper Settings for the xTool F1 Lite

The xTool F1 Lite cuts 0.2mm Kraft Paper cleanly at 20 mm/s with 90% power. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For 0.2mm Kraft Paper, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for 0.2mm Kraft Paper on the xTool F1 Lite?↓

For cutting 0.2mm Kraft Paper on the xTool F1 Lite, start at 20 mm/s speed and 90% power. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for 0.2mm Kraft Paper on the xTool F1 Lite?↓

Air assist is strongly recommended when cutting 0.2mm Kraft Paper. It clears smoke from the cut path, reduces charring, and helps protect your laser lens.

How many passes to cut through 0.2mm Kraft Paper on the xTool F1 Lite?↓

The manufacturer recommends 1 pass to cut through 0.2mm Kraft Paper at 20 mm/s and 90% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my xTool F1 Lite cutting through 0.2mm Kraft Paper?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.