xTool D1 Pro 5W Laser Settings for Cork Desk Pad

2 verified settings · manufacturer data · diode laser · Updated January 2026

Quick Answer — Best Score Setting5W

Speed (mm/s)

100%

Power

Passes

Air assist: NoSource: xTool LightBurn Library (5W)

Operation	Speed (mm/s)	Power (%)	Passes	Air Assist	Notes
score	50	100%	1	—	LightBurn Library: Cut
engrave	40	20%	1	—	LightBurn Library: Cut

About Cork Desk Pad Settings for the xTool D1 Pro 5W

The xTool D1 Pro 5W cuts Cork Desk Pad cleanly at 50 mm/s with 100% power. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For Cork Desk Pad, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for Cork Desk Pad on the xTool D1 Pro 5W?↓

For cutting Cork Desk Pad on the xTool D1 Pro 5W, start at 50 mm/s speed and 100% power. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for Cork Desk Pad on the xTool D1 Pro 5W?↓

Air assist is not required for Cork Desk Pad on the xTool D1 Pro 5W according to manufacturer data, though it can still help reduce smoke and improve cut quality on organic materials.

How many passes to cut through Cork Desk Pad on the xTool D1 Pro 5W?↓

The manufacturer recommends 1 pass to cut through Cork Desk Pad at 50 mm/s and 100% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my xTool D1 Pro 5W cutting through Cork Desk Pad?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.