xTool D1 Pro 20W 6mm Ash plywood 30*30 Laser Settings

xTool D1 Pro 20W Laser Settings for 6mm Ash plywood 30*30

4 verified settings · manufacturer data · diode laser · Updated January 2026

Quick Answer — Best Cut Setting20W

Speed (mm/s)

20%

Power

Passes

Air assist: NoSource: xTool LightBurn Library (20W)

Operation	Speed (mm/s)	Power (%)	Passes	Air Assist	Notes
score	60	80%	1	—	LightBurn Library: Cut
cut	3	20%	1	—	LightBurn Library: Cut
engrave	100	20%	1	—	LightBurn Library: Cut
fill	100	20%	1	—	LightBurn Library: Cut

About 6mm Ash plywood 30*30 Settings for the xTool D1 Pro 20W

The xTool D1 Pro 20W cuts 6mm Ash plywood 30*30 cleanly at 3 mm/s with 20% power. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For 6mm Ash plywood 30*30, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for 6mm Ash plywood 30*30 on the xTool D1 Pro 20W?↓

For cutting 6mm Ash plywood 30*30 on the xTool D1 Pro 20W, start at 3 mm/s speed and 20% power. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for 6mm Ash plywood 30*30 on the xTool D1 Pro 20W?↓

Air assist is not required for 6mm Ash plywood 30*30 on the xTool D1 Pro 20W according to manufacturer data, though it can still help reduce smoke and improve cut quality on organic materials.

How many passes to cut through 6mm Ash plywood 30*30 on the xTool D1 Pro 20W?↓

The manufacturer recommends 1 pass to cut through 6mm Ash plywood 30*30 at 3 mm/s and 20% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my xTool D1 Pro 20W cutting through 6mm Ash plywood 30*30?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.