Generic CO2 40-60W Papier Laser Settings

Generic CO2 40-60W Laser Settings for Papier

1 verified settings · manufacturer data · co2 glass laser · Updated January 2026

Quick Answer — Best Cut Setting50W

3.33

Speed (mm/s)

85%

Power

Passes

Air assist: NoSource: tgfuellner Community CO2 Library

Operation	Speed (mm/s)	Power (%)	Passes	Air Assist	Notes
cut	3.33	85%	1	—	LightBurn Library: Cut [bidir=true, overscan=0]

About Papier Settings for the Generic CO2 40-60W

The Generic CO2 40-60W cuts Papier cleanly at 3.33 mm/s with 85% power. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For Papier, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for Papier on the Generic CO2 40-60W?↓

For cutting Papier on the Generic CO2 40-60W, start at 3.33 mm/s speed and 85% power. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for Papier on the Generic CO2 40-60W?↓

Air assist is not required for Papier on the Generic CO2 40-60W according to manufacturer data, though it can still help reduce smoke and improve cut quality on organic materials.

How many passes to cut through Papier on the Generic CO2 40-60W?↓

The manufacturer recommends 1 pass to cut through Papier at 3.33 mm/s and 85% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my Generic CO2 40-60W cutting through Papier?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.