Algolaser Delta Navy Blue Canvas Laser Settings

Algolaser Delta Laser Settings for Navy Blue Canvas

2 verified settings · manufacturer data · diode laser · Updated January 2026

Quick Answer — Best Engrave Setting40W

416.67

Speed (mm/s)

50%

Power

Passes

Source: Algolaser

Operation	Speed (mm/s)	Power (%)	Passes	Air Assist	Notes
engrave	416.67	50%	1	—	—

About Navy Blue Canvas Settings for the Algolaser Delta

The Algolaser Delta cuts Navy Blue Canvas cleanly at 416.67 mm/s with 50% power. Because the Algolaser Delta is available in multiple wattage variants (40W, 22W), settings are grouped by wattage above — select your laser's wattage to see the right numbers. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For Navy Blue Canvas, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for Navy Blue Canvas on the Algolaser Delta?↓

For cutting Navy Blue Canvas on the Algolaser Delta, start at 416.67 mm/s speed and 50% power. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for Navy Blue Canvas on the Algolaser Delta?↓

Air assist is strongly recommended when cutting Navy Blue Canvas. It clears smoke from the cut path, reduces charring, and helps protect your laser lens.

How many passes to cut through Navy Blue Canvas on the Algolaser Delta?↓

The manufacturer recommends 1 pass to cut through Navy Blue Canvas at 416.67 mm/s and 50% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my Algolaser Delta cutting through Navy Blue Canvas?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.