Algolaser Alpha Laser Settings for Red Oak

6 verified settings · manufacturer data · diode laser · Updated January 2026

Quick Answer — Best Cut Setting22W

3.33

Speed (mm/s)

100%

Power

Passes

Source: Algolaser

Operation	Speed (mm/s)	Power (%)	Passes	Air Assist	Notes
cut	3.33	100%	10	—	—

About Red Oak Settings for the Algolaser Alpha

The Algolaser Alpha cuts Red Oak cleanly at 3.33 mm/s with 100% power over 10 passes. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For Red Oak, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for Red Oak on the Algolaser Alpha?↓

For cutting Red Oak on the Algolaser Alpha, start at 3.33 mm/s speed and 100% power with 10 passes. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for Red Oak on the Algolaser Alpha?↓

Air assist is strongly recommended when cutting Red Oak. It clears smoke from the cut path, reduces charring, and helps protect your laser lens.

How many passes to cut through Red Oak on the Algolaser Alpha?↓

The manufacturer recommends 10 passes to cut through Red Oak at 3.33 mm/s and 100% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my Algolaser Alpha cutting through Red Oak?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.