Skip to main content

MOPA 150mm lens Laser Settings for Brass

15 verified settings · manufacturer data · fiber mopa laser · Updated July 2026

Quick Answer — Best Mark Setting60W
500 mm/s
Speed
40%
Power
5
Passes
Source: OMG Laser
OperationModeSpeedPower (%)PassesAir AssistNotes
mark—500 mm/s40%5—Blacken step (5 passes) of black & deep engraving brass recipe.
engrave—2,000 mm/s90%10—Deep step (10 passes) of black & deep engraving brass recipe.

About Brass Settings for the MOPA 150mm lens

The MOPA 150mm lens cuts Brass cleanly at 500 mm/s with 40% power over 5 passes. Because the 150mm lens is available in multiple wattage variants (60W, 50W, 20W), settings are grouped by wattage above — select your laser's wattage to see the right numbers. Always test on a scrap piece first — every machine is slightly different, and variables like tube age, lens condition, and material batch can shift results.

For Brass, the key variables to dial in are speed and power. If the laser isn't cutting through cleanly, slow down or add a pass before pushing power higher — excessive power causes charring and wider kerfs. Air assist is highly recommended for wood and organic materials to clear smoke and protect the lens.

Once you find settings that work, save them in Laser Lab to build your personal settings library. The AI predictor uses your calibrated results to suggest starting points for new materials automatically — so the more you log, the smarter it gets.

Frequently Asked Questions

What speed and power for Brass on the MOPA 150mm lens?↓

For cutting Brass on the MOPA 150mm lens, start at 500 mm/s speed and 40% power with 5 passes. These are manufacturer-verified starting points — always test on scrap first.

Do I need air assist for Brass on the MOPA 150mm lens?↓

Air assist is strongly recommended when cutting Brass. It clears smoke from the cut path, reduces charring, and helps protect your laser lens.

How many passes to cut through Brass on the MOPA 150mm lens?↓

The manufacturer recommends 5 passes to cut through Brass at 500 mm/s and 40% power. If the cut isn't clean, try reducing speed slightly before adding more passes.

Why isn't my MOPA 150mm lens cutting through Brass?↓

Incomplete cuts are usually caused by incorrect power, speed, or focus distance. If edges are charred, try increasing speed or reducing power. If the laser isn't cutting through, reduce speed or increase power — or add an extra pass. Also verify your focal distance is correct for the material thickness and that your lens is clean.

More Settings for the MOPA 150mm lens

Save Your Own MOPA 150mm lens Settings

Track what works, get AI predictions for new materials, and share with the community. Laser Lab is free to start.

Laser Lab

Save Your MOPA 150mm lens Settings

Track what works. Get AI-predicted starting points for any material.

Try Laser Lab Free →Download as PDF

Machine Info

BrandMOPA
Model150mm lens
Laser Typefiber mopa
Variants60W, 50W, 20W
Records15
Browse all MOPA 150mm lens materials →

Other MOPA 150mm lens Materials